Frontier ST7526, Руководство оператора

Страница: 11 / 44

UPPER HANDLE AND CRANK ASSEMBLY
1. Loosen, but do not remove the screws, flatwashers, lock-
washers and hex nuts in the upper holes of the lower handle.
2. Remove the fasteners and the crank assembly eyebolt from
the lower holes of the lower handle.
3. Raise upper handle into operating position. Upper handle
should be to the outside of the lower handle.
NOTE: Make sure the cables are not caught between the
upper and lower handle.
4. Install the fasteners and the crank assembly eyebolt that were
removed in step 2. DO NOT tighten until all fasteners are in
place.
5. Attach the crank rod to the universal joint assembly with the
hair pin (see Figure 6).
6. Tighten nut on eye bolt. Make sure eye bolt is properly aligned
and the crank can freely rotate.
7. Tighten all handle bolts.
NOTE: Make sure crank does not touch carburetor cover.
CHECK THE CABLES
1. If control cables have become unattached from motor mount
frame, reconnect cables as shown in Figure 7.
2. For cable adjustments, see “How To Check And Adjust The
Cables” in the MAINTENANCE section.
HOW TO SET THE LENGTH OF THE CABLES
The cables were adjusted at the factory and no adjustments should
be necessary. However, after the handles are put in the operating
position, the cables can be too tight or too loose. If an adjustment
is necessary, see “How To Check And Adjust The Cables” in the
MAINTENANCE section.
Figure 7
Traction Drive Cable
Auger Drive Cable
Hair Pin
Universal Joint
Crank Rod
Assembly
Figure 6
Figure 5
Crank
Bolt
Eye Bolt
Locknut
Flatwasher
Flatwasher
Lockwasher
Nut
ASSEMBLY
11