Frontier ST7526, Руководство оператора

Страница: 10 / 44

Figure 2 shows the snowthrower in the shipping position.
Figure 3 shows the snowthrower completely assembled.
Reference to right and left hand side of the snowthrower is from
the operator’s position at the handle.
UNPACKING
1. Locate the two tear tabs at the bottom of the carton.
2. Pull the tear tape no more than twelve inches (30.48 cm) at a
time. Regrasp tape next to the carton and pull again. Repeat
until all the tape is torn off.
3. After the tape has been completely removed from the carton,
remove the carton from the base. Cut all four corners and fold
the sides toward the center for easy disposal.
4. Remove the plastic bag that covers the unit.
5. Locate and remove the parts bag.
NOTE: Set the fuel stabilizer aside until adding gasoline to
the fuel tank. We recommend that fuel stabilizer is added to
the fuel each time that gasoline is added to the fuel tank.
6. For shipping purposes, the height adjust skids are attached to
the pallet. Remove the screw that secures each height adjust
skid to the pallet (see Figure 3).
7. Roll the snowthrower off the carton by pulling on the lower
handle.
CAUTION: DO NOT back over cables.
8. Remove the packing material from the handle assembly.
9. Cut ties securing the clutch control cables to the lower handle.
Figure 4
“Z” Fitting
Driver Lever
Cable
Figure 3
Auger Drive Lever
Snow Chute Deflector
Auger Housing
Height Adjust
Skid
Screw
Traction Drive Lever
Figure 2
ASSEMBLY
10