Fronius TPS 320i, Руководство по эксплуатации

Страница: 56 / 106

54
MIG/MAG welding
Safety
MIG/MAG welding
- overview The "MIG/MAG welding" section comprises the following steps:
-
Switching on the power source
- Selecting the welding process and operating mode
- Selecting the filler metal
- Setting the welding and process parameters
- Setting the shielding gas flow rate
- MIG/MAG welding
Switch on the
power source Insert the mains cable
Move the mains switch to the I position
A cooling unit connected to the system will begin to operate.
For the best welding results, Fronius recommends that an R/L adjustment is carried out
every time the device is switched on.
More information about the R/L adjustment can be found under "R/L adjustment" in the
"Process parameters" section of this chapter.
Setting the weld-
ing process and
operating mode Setting the welding process
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
-
these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
WARNING! An electric shock can be fatal. If the power source is connected to the
mains electricity supply during installation, there is a high risk of very serious in-
jury and damage. Before carrying out any work on the device make sure that:
-
the power source mains switch is in the "O" position
- the power source is unplugged from the mains
NOTE! If using a cooling unit, follow the safety rules and note the operating con-
ditions in the cooling unit operating instructions.
1
2