Fronius TPS 320i, Руководство по эксплуатации

Страница: 75 / 106

73
EN
Press "Finish"
(or press the adjusting dial)
Process parame-
ters for compo-
nents The following process parameters can be set and displayed for the system components of
a welding device:
10
Values:
R = 1,3 mOhm (before: 1,7 mOhm)
L = 5,0 µH (before: 4,0 µH )
> The R/L adjustment has been performed successfully.
To finish the wizard press “Finish“ .
AlMg 5
10
Cooling unit mode
to determine whether a cooling unit is to be switched on or off, or operated automatically
Setting range eco / auto / on / off (depending on the cooling unit)
Factory setting auto
Flow watchdog filter time
for setting the time from when the flow watchdog responds until a warning message is
output
Unit s
Setting range 5 - 25
Factory setting 5
Feeder inching speed
for setting the wire feed speed at which the wire electrode is threaded into the torch
hosepack
Unit m/min
Setting range min. - max.
Factory setting -