Fronius Symo GEN24 10.0, Руководство по эксплуатации, Страница: 48 / 120

Install the mounting bracket and hang up the
inverter
Selecting the fix-
ing material Use the corresponding fixing materials depending on the subsurface and observe the
screw dimension recommendations for the mounting bracket.
The installer is responsible for selecting the right type of fixing.
Properties of the
mounting bracket The separate mounting bracket (illustra-
tion) is also used as the gauge.
The pre-drilled holes on the mounting
bracket are intended for screws with a
thread diameter of 6 - 8 mm (0.24 - 0.32
inches).
Unevenness on the installation surface (for
example, coarse-grained plaster) is largely
counterbalanced by the mounting bracket.
Do not deform
the mounting
bracket
NOTE!
When fitting the mounting bracket to the wall or column, ensure that the mounting
bracket does not become deformed.
A deformed mounting bracket may make it difficult to clip/swivel the inverter into position.
Fitting the mount-
ing bracket to a
wall IMPORTANT!
When installing the mounting bracket, make sure that it is installed with the arrow point-
ing upwards.
1 2
48