35
EN
Area of applica
-
tion for Drive Ea
-
syTwin - steel,
diameter 1.2 mm -
1.0 mm
The Drive EasyTwin characteristic range covers Vd. = 5 m/min (one power source) to Vd.
= 15 m/min.
This range is determined by the following
-
The filler metal 1.0 is the absolute upper load capacity limit at Vd. = 15 m/min
-
As there is only one wire-feed motor, this is protected from overload
The working range is Vd. = 10.5 m/min to Vd. = 15 m/min.
The Vd. range below 10 m/min. is only intended for up and downslope.
The range from Vd. = 8.5 m/min to Vd.= 10.5 m/min is a transition range in which the 1.2
mm filler metal (lead power source) changes to a modified spray arc. This change occurs
at Vd. = 9 m/min or Vd. = 10 m/min depending on the shielding gas used (characteristic).
This range should be avoided as a production parameter.
Welding technol
-
ogy options
IMPORTANT!
The weld seam length is limited to a maximum of 5 m for all the applications listed.
68,5°
Single layer fillet welds/PA position:
Sheet thickness:
from 3 mm
a-dimension single
layer:
a3 - a6
a3:
Vs-2 m/min
a6:
Vs-0.5 m/min
If an a-dimension greater than 6 mm is required, then multi-lay
-
er technology is recommended.
Single layer fillet welds/PB position:
Содержание Drive EasyTwin
