29
EN
System requirements
System require
-
ments and mini
-
mum equipment
for Drive Ea
-
syTwin
Drive EasyTwin
mechanical re
-
quirements
For a stable and reproducible "Drive EasyTwin" process, the following mechanical require
-
ments must be met:
-
Precise torch guidance for robots or single-purpose machines (e.g. straight-line car
-
riage)
-
Exact joint preparation
-
Low component tolerances
-
Seam guidance system with low deviation
-
Due to the system, a wirefeeder is not required on the 3rd shaft
Welding torch:
1 x Robacta Twin Compact PB ED
Drive:
1 x Robacta Drive EasyTwin
Torch hosepack:
1 x Robacta Drive EasyTwin W/FB
Power sources:
2 x TPS 5000 (+ variants)
1 x control unit
Cooling unit:
1 x FK 4000-R FC
LEADING
TRAILING
control line
gas line /
blow out line
Содержание Drive EasyTwin
