Fritsch ANALYSETTE 28 IMAGESIZER, Руководство по эксплуатации

Страница: 21 / 62

21
Installation
Make sure that the ANALYSETTE 28 ImageSizer stands on the
surface evenly balanced. Failure to observe this information
may lead to problems with feeding on the feeder. All feet of
the ANALYSETTE 28 ImageSizer are adjustable and can be used
to balance the device.
NOTICE
Never operate ANALYSETTE 28 ImageSizer while it is standing
on the transport pallet!
■
Make sure that:
–
all switches / control elements are easy to access;
–
the connections (USB, network connections) are freely accessible.
■
Please store the transport packaging so that it can be reused if you need to
return the product. Fritsch GmbH accepts no liability for damage caused by
improper packaging (non-original packaging).
4.4.1 Transport securing devices
Proceed as follows to remove the transport securing device:
1.
Loosen the two knurled screws on the funnel holder.
2. Unscrew the funnel holder until it is over the transport securing device.
3. Loosen the two knurled screws on the vibration feeder holder and pull out
the transport securing device towards the front.
4.5 Ambient conditions
WARNING
Mains voltage
−
The device may only be operated indoors.
−
The surrounding air must not contain any electrically con-
ductive particles.
−
Maximum relative humidity 80% for temperatures up to 31
°C, linearly decreasing down to 50% relative humidity at 40
°C.
■
The room temperature should be between 5 and 40 °C.
■
Storage and transport is possible between 1 and 40 °C.
■
If stored or transported below 10 °C, you must wait until the device has
warmed up to ambient temperature before switching on.