Frigomat AGG.2014 Series, Руководство по эксплуатации и обслуживанию

Страница: 53 / 96

ENGLISH - 52
7.2.2 OMEGA² BATCH FREEZER BOARD PROGRAMMING
Refer to the following instructions to program the circuit board:
1. Make sure that the door is closed and the
safety grid is lowered.
2. Power the machine.
3. With the machine at STOP, press “MIXING”
and “AUTOMATIC” simultaneously and
release them only after the password
identification screen appears (Fig. 1).
4. Press the “MIXING” (
▲
)”, “AUTOMATIC” and
“EXTRACTION” ( ◄► )” keys simultaneously to
type in the password and then confirm it.(Fig.
2). If you do not know the password, contact
the Frigomat assistance service.
5. When the password has been accepted, the
screen accesses the list of programming steps
directly. The first programming step P1 is
selected automatically and flashes (Fig.3).
6. If you do not wish to change the value of the
selected step, press “MIXING” (
▲
)” to directly
access the following step (Fig. 4).
7. If, instead, you wish to change the selected
step, press “EXTRACTION” (
◄►
)” to access
the parameters relative to the same step, and
subsequently
press “MIXING” ( ▲ )” or
“AUTOMATIC” to increase or decrease the
value.
Subsequently, press the
“EXTRACTION” ( ◄► )” key to confirm the
data (Fig.5).
8. To exit programming and save the changes
press the “STOP” key (Fig. 6).
Fig.1
Fig.2
Fig.4
Fig.5
Fig.6
Fig.3