Frigomat AGG.2014 Series, Руководство по эксплуатации и обслуживанию

Страница: 35 / 96

ENGLISH - 34
6.6.2 SEMI – AUTOMATIC CYCLE WITH CONSISTENCY CONTROL.
(only for experts)
- Press the SEMI-AUTOMATIC key to select
the semi-automatic batch freezing cycle with
consistency control (Fig. 1).
- The LEDs of the UP ( ▲ ), Confirm ( ◄► ) and
DOWN (
▼
) keys light up and the numbers
relative to the consistency setting to be
configured, expressed by a numerical value
between 60 and 250, appear on the display:
press the “UP (
▲
)” and “DOWN (
▼
)” keys to
increase or decrease this value (Fig. 2).
Higher consistencies correspond to high
numbers, lower consistencies correspond to
low numbers.
The maximum programmable consistency
value is equal to 250 numbers but not all
mixtures and not all quantities can reach such
a high consistency value.
For a reduced amount of mixture it is
recommended to not select consistency
numbers close to 250.
- Subsequently, press the Confirm (
◄►
) key
to start a new batch freezing cycle (Fig.3).
- The SAC message is viewed on the display
for a few seconds to confirm the semi-
automatic cycle has been selected (Fig. 4);
subsequently, during batch freezing, the
instantaneous consistency numerical value is
displayed.(Fig. 5).
- After a few minutes and once the consistency
level selected during the programming phase
has been reached, an intermittent acoustic
signal warns the operator that it is possible to
extract the ice cream (Fig. 6). If this should
not be immediately possible, the machine will
automatically see to maintain the ice cream
over time without changing its consistency
any further.
Fig.4
Fig.5
Fig.2
Fig.3
Fig.6
Fig.1