Frigomat AGG.2014 Series, Руководство по эксплуатации и обслуживанию

Страница: 37 / 96

ENGLISH - 36
6.6.3 SLUSH
- With the machine at STOP, press the STOP and
SEMI-AUTOMATIC keys at the same time to
access the slush production program with
consistency control and continuous mixing (Fig.
1).
- The SLUSH LED switches on to signal that one
has accessed the SLUSH mode.
- The LEDs of the UP (
▲
), Confirm (
◄►
) and
DOWN ( ▼ ) keys light up and the numbers
relative to the consistency setting to be
configured, expressed by a numerical value
between 120 and 180, appear on the display:
press the UP (
▲ ) and DOWN ( ▼ ) keys to
increase or decrease the value (Fig.2). Higher
consistencies correspond to high numbers, lower
consistencies correspond to low numbers.
The maximum programmable consistency value
is equal to 180 numbers but not all mixtures and
not all quantities can reach such a high
consistency value.
For a reduced amount of mixture it is
recommended to not select consistency numbers
close to 180.
- Subsequently, press the Confirm ( ◄► ) key to
start a new slush production cycle (Fig.3).
- The GR1 message is viewed on the display for a
few seconds to confirm the slush cycle has been
selected
(Fig. 4); subsequently, during
production, the instantaneous consistency
numerical value is displayed.(Fig. 5).
- After a few minutes and once the consistency
level selected during the programming phase
has been reached, an intermittent acoustic signal
warns the operator that it is possible to extract
the product (Fig.6). If this should not be
immediately
possible, the machine will
automatically see to maintain the product over
time without changing its consistency any further.
- During the maintenance phases of the reached
consistency setting, the indicator of the SEMI-
AUTOMATIC key flashes (Fig.7).
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6