Frigomat AGG.2014 Series, Руководство по эксплуатации и обслуживанию

Страница: 51 / 96

ENGLISH - 50
7.2 EXTRAORDINARY MAINTENANCE (INTENDED FOR QUALIFIED PERSONNEL)
These operations are reserved exclusively for authorised qualified personnel. FRIGOMAT
S.r.l. will not be held liable for damage to objects or harm to persons which occur due to
failure to comply with the above.
7.2.1 HEATER MEB² BOARD PROGRAMMING
Refer to the following instructions to program the circuit board:
1. Ensure the lid is assembled in machine and in
closing position.
2. Power the machine.
3. With the machine at STOP, press the “STOP” and
“MIXING” keys simultaneously and release them
only after the password identification screen
appears (fig.1).
4. Press the “MIXING” ( ▲ ), “85° AUTOMATIC” ( ▼ )
and “SEMIAUTOMATIC” (
◄►
) keys to enter the
password and then confirm it (fig.2). If you do not
know the password, contact the Frigomat
assistance service.
5. When the password has been accepted, the
screen accesses the list of programming steps
directly. The first programming step P01 is
selected automatically
6. If you do not wish to change the value of the
selected step, press “MIXING” ( ▲ )” to directly
access the following step (Fig. 3).
7. If, instead, you wish to change the selected step,
press “SEMI-AUTOMATIC” ( ◄► )to access the
parameters relative to the same step, and
subsequently
press “MIXING” (
▲
)
“85°AUTOMATIC” ( ▼ ) to increase or decrease
the value (fig.4). Subsequently, press the “SEMI-
AUTOMATIC” (
◄►
)” key to confirm the data.
8. To exit programming and save the changed press
the "STOP" key.
Fig.1
Fig.2
Fig.3
Fig.4