Frigidaire FRS095YC1, Инструкция по эксплуатации

Страница: 8 / 28

Fixing the Installation Plate
Drilling the Hole
1. Install the installation plate
horizontally over the structural
parts on the wall using the spaces
indicated on the plate, as shown in
the figure above.
2. In the case of tiled, concrete or
similar walls, create 5 mm-diameter
holes. Place anchorage supports
for the appropriate assembly
screws.
3. Fix the installation plate to the wall
with 8 A type screws.
1. Determine the position of the hole for
the pipe using the installation plate
and drill the pipe hole so that it is
titled slightly downward.
2. Always use a pipe cover with an
opening when drilling a metal bar.
Installation plate
Fit the Installation Plate and drill
holes in the wall according to the
wall structure and corresponding
mounting points on the installation
plate (Dimensions are in “mm”
unless otherwise stated).
Wall
Indoor unit Outdoor unit
5
-7
m
m
13 14
Attention
above 150mm from ceiling
above 120mm
from wall
1080
330
above 120mm
from wall
130
108 432 432
130
22
Refrigerant pipe
hole (left) Ø 95
50 50
Indoor unit outline
Models 24000 Btu's
Models 30000 Btu's
325
55
55
1250
815 257 178
55
58
above 150mm from ceiling
above 120mm
from wall
above 120mm
from wall
Refrigerant pipe
hole (right) Ø 95
Indoor unit outline
Models 30000 Btu's
Models 36000 Btu’s
Do not put the end
of drain hose into water.
Do not block
water flow
by a rise. Do not block
water flow
by a rise.
Connective pipe and drainage installation
Drainage
1. Run the drain hose sloping
downward. Do not install the drain
hose as illustrated below.
2. When connecting extension drain
hose, insulate the connecting part
of extension drain hose with a
shield pipe, do not let the drain
hose slack.
Connective pipe
1. For the left-hand and right-hand
piping, remove the pipe cover from
the side panel. Explain to clients
that the pipe cover must be kept as
it may be used when relocate the air
conditioner to any other place.
2. For the rear-right-hand and rear-left-
hand piping, install the piping as
shown. Bend the connective pipe to
be laid at 43mm height or less from
the wall. Fix the end of the
connective pipe.
Right back
piping
Pipe cover
(left) Pipe
holder Pipe cover
(right)
Right piping
Connective
pipe
Indoor unit
outline
43mm