ADJUST THE OVEN BURNER FLAME
Adjust the air shutter. It is
located on the venturi
tube, which sets on the
hood of the valve, and is
locked in place with a
Phillips head screw. If it
needs adjusting, loosen
the screw and rotate the
shutter to allow more or
less air into the burner
tube. See Figure 8
To determine if the oven
burner flame is proper,
observe the flame. It
should be steady with ap-
proximately 1” blue
cones and the fame
should not extend out
over the edges of baffle.
For LP gas, this will most likely occur when the air
adjustment shutter is completely open. See Figure 9.
Turn OVEN TEMP knob to 300°F. and allow oven to cycle on
and off.
To replace broiler drawer or lower bottom, reverse steps
taken
for removal. Replace oven rack and/or broiler pan.
SERIAL PLATE LOCATION
The Serial Plate is located on the left side inner trim of the
oven.
When ordering parts for or making inquiries about your ap-
pliance, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate on
your appliance. Refer to the Owner’s Manual for complete
instructions.
Your serial plate also tells you the ratings of the burners
and type of fuel and pressure the appliance was adjusted
for when it left the factory.
BEFORE YOU CALL FOR SERVICE
Check to make sure the house fuses or circuit breaker for
your oven are not blown or open.
CARE CLEANING AND MAINTENANCE
If removing the unit is necessary for cleaning or mainte-
nance, shut off gas supply. Disconnect the gas supply line.
Remove installation screws from front frame and lower
grille. Pull out only as far as necessary to disconnect the
electric supply line. After disconnecting the gas and electric
supply, finish removing the unit for servicing and cleaning.
Reinstall in reverse order making sure to level the appliance
and check gas connection for leaks.
AFTER INSTALLATION IS COMPLETE MAKE SURE ALL
CONTROLS ARE LEFT IN THE OFF POSITION.
Reset all controls to the “OFF” position after using a
programmable timing operation.
6
NOTE:
Refer to Owner’s Guide for operating in-
structions and cleaning instructions.
CAUTION: POWER FAILURE
DO NOT attempt to operate the oven in the event
of a power failure. If a power failure should occur
during operation, turn the oven control to the off
position. Failure to turn the oven control off will
result in oven operation upon resumption of
power to the unit.
AIR
ADJUSTMENT
SHUTTER
LOOSEN
Figure 8
Figure 9
WARNING:
Stepping, leaning or sitting on the
doors or drawers of this appliance can result in
serious injuries and also cause damage to the
appliance.
