Friendly Robotics Robomow RL1000, Инструкция по эксплуатации и безопасности

Страница: 61 / 73

61
Message Displayed Probable Cause/Event Corrective/User Action
Low battery
- Mower is searching for the Docking
Station but the battery voltage is too
low to continue the searching process
- Drive the mower manually for charging in the
Docking Station
Low temp.
Disc. charger
- Robomow is charged through the plug
and ambience temperature is out of
range (below 32 ºF / 0 ºC); disconnect
the charger plug from the Robomow.
-
Robomow charging is not allowed when the
ambience temperature is going down below
32ºF / 0ºC; Disconnect the charger plug and
wait until the temperature will go down or take
the Robomow to be charged in a warmer
place.
Low temp.
Waiting…
- Robomow is charged through the
Docking Station and the ambience
temperature is out of range (below
32ºF / 0ºC);
- Do not do anything, the charging is stopped
and Robomow is waiting for temperature to
change back to the allowed range; if
temperature stays out of the range for more
than 12 hours, the message is changed to
‘Low temp. Press GO’.
Move from Wire
- The Robomow is positioned too close
or on top of the perimeter wire
- Move the Robomow approximately 6 – 10 feet
(1.5 – 3m) away from the perimeter wire and
start again.
Mowing Overload
Cooling, Wait
- The mowing motors have been
working under a severe load for too
long of a time.
- Wait until the message ‘ Mowing Overload –
Press GO’ is displayed.
No Wire Signal
- Perimeter Switch is not turned on or
not connected to the zone intended to
mow
- Make sure the Perimeter Switch is connected
to the correct zone and is turned on
Ready
Keep Charging
- The battery is fully charged
- Keep the charger (power supply) connected
and operating
Recharge Battery
- The maximum operating time has
been reached
- Connect the charger to the mower
Replace blades
every 200 hours
- An automatic reminder to replace the
blades is displayed every 200 hours
- Replace the blades and restart the counter of
the blades replacement reminder by choosing
the ‘
Blades replaced – Clear reminder’
option under the ‘ User Preferences’ menu
Replace lamp
- The Operating Lamp is burnt out
-
Confirm the message and replace the
Operating Bulb as soon as possible
Retry elsewhere
- Calibration failure from interference in
the immediate area - Move the Robomow 10-12 feet (3-4m) from
this spot and attempt calibration again.
Set Country
- Displayed only on first use. - Follow prompts on LCD screen to set country
Set Time
- Displayed every time the power pack
is taken out of the mower (reset
operation)
- Set real time clock (day and hour)
Skipped: Low bat
- Robomow has skipped the last depart
due to low battery voltage
- Confirm there is enough time between the two
adjacent departures so the battery can be
charged prior the scheduled operation (min 16
hours between operations)
- An unknown fault has occurred and
user help is required - Manually drive the mower away from this
particular area and restart operation
Start Elsewhere
- Wheel drive motors have been working
under a severe load - Check to insure the mower is not stuck,
allowing the wheels to slip
Thermistors fail
- Faulty / disconnected thermistors
(overheat protection)
- Contact service provider
Time Completed
- The operating time set for that zone
has been reached - Connect to the charger if all mowing has been
completed for the day.