Friedrich VRP12K, Руководство по обслуживанию и запасным частям

Страница: 93 / 221

93 PB
26
Wall Controller Installation
Step 2: Wiring the VRP Unit
A.
Remove
the
wall mount bracket from
the
wall controller.
B. Insert the wires from back of wall mount bracket.
C.
Strip
the
wire ends 9/16
"
(15 mm)
.
D. Insert the wire pairs into the terminals as shown below .
E. Tighten the screws to secure the wires to the
corresponding terminals.
F. Pull the wires to check that they are securely affixed to the
terminal block .
G. Position the wires so that the wall controller bracket fits
securely on the wall.
A.
Strip
the
wire ends to 9/16
"
(15 mm)
.
B.
Insert
the
wire pairs into terminals as shown below
.
C. Insert g round s hield w ire into ground terminal ( marked with a
ground symbol
).
D. Tighten the screws to secure the wires to the corresponding
terminals.
E. Pull the wires to check that they are securely affixed to the
terminal block.
Step 1: Wiring the VRPXWC Wall Controller
INSTALLATION
Wall Controller Installation 12 & 24k