23
920-087-06
Appendix A: Electrical Wiring for 265 Volt Models
1. Remove the four control box retaining screws (A) and open
the control box.
2. Pull the chassis power lead wires (B) (located on the
bottom-right side of the control box) through the plastic
bushing so they are located inside the control box.
3. Remove the plastic bushing.
4. Route the line voltage power leads through the hole where
the plastic bushing was located, and secure its conduit
(use a ½" straight conduit connector, with the locknut on
the inside of the control box.)
NOTE: It is recommended that the PXSB subbase assembly, the PXCJ conduit kit (or equivalent) be installed on all hardwired units.
If installing a
fl
ush-
fl
oor mounted unit, make provisions for all the line voltage power leads and conduit to be removed for ease of
maintenance and service to the chassis.
Line Voltage Connections
Figure 18
5. Make the appropriate electrical connections within the
control box, then secure the box on the chassis. Detailed
instructions are included with the installation instructions
for the conduit kit (PXCJ).
6. Route the line voltage power conduit from the control
box straight down the right front to the bottom side of
the chassis. This will allow the front cover to be installed
without interference with the electrical conduit.
To install the line voltage power leads and conduit to the chassis, follow the instructions below.
Inside back of control
panel cover.
Screws
Screws
Fuse holder
ELECTRIC SHOCK HAZARD!
Turn off electric power before service or installation. All electrical connections and wiring
MUST
be installed by a quali
fi
ed electrician and conform to the National Electrical Code and all local codes which have
jurisdiction. Failure to do so can result in property damage, personal injury and/or death.
WARNING
