have the DIP switches in a
Remote Control set as shown.
The corresponding settings of
the house code DIP switches
(1-8) in the Interface Module
would be as follows:
5 ) S w i t c h e s 9 , 1 0 , 1 1 a n d 1 2
configure the interface to operate
with a Smoke Alarm and SA3,
SA4 or SA5 type alarm system.
They must be set as follows:
D I P 9 D I P 1 0 D I P 1 1 D I P 1 2
= +
= 0
= 0
= 0
1
2
3
4
5
6
7
8
9
1
1
0
1
2
6 ) Insert the two coin cell batteries
into the interface under the
battery clip ensuring that the
+
terminals face upwards.
The indicator LED will illuminate
for approximately 1 s.
Testing the Interface Module:
7 ) Place the alarm system Control
Panel into Test Mode and select
Walk Test or Detector Test as
appropriate to your s ystem
(refer to the Testing section of
your alarm Installation and
Operating Manual).
8 ) Press the TAMPER switch on
the Interface Module
–
The indicator LED will illuminate for
approx 1 s to show a signal has
been transmitted.
–
The Control Panel should beep
and indicate a TAMPER signal
on the LEDs or Display.
If the Control Panel does not
respond correctly remove the
batteries and recheck steps 2 to
10 before proceeding.
3
Wirefree Alarm Interface Module
