Fri-Jado BS10i, Руководство по обслуживанию

Страница: 10 / 88

PROGRAMMING INSTRUCTIONS
Page 10
Service Manual Bake Star intelligent
PKII
form 9123665 rev. 06/2013
Boost function.
• This function can be activated during the cooking proces. (in the bottom line of the
display it says “Press power for extra time”). See in the above diagram from #11-#14.
• Even after opening and closing the door, it is still possible to give in extra cooking time.
The program calculates the surface from the
diagram below the curved line. (tempera-
ture * time). The result is the so called heat
number. This heat number is stored into
the cooking program.
All further cooking programs will try to get
the same heat number.
The second diagram shows an example with
full load. It takes more time for the unit to
reach the programmed cooking tempera-
ture. See dashed line. The surface above
the dashed line represents the missing part
of the heat number. The cook correction
will put this missing part behind the nor-
mal cooking time. Therefore extra time is
added in order to reach the desired heat
number.
It is also possible that time is deducted in case
a smaller load has been put into the oven.
Time will be added in case of:
A bigger load.
A colder load. (straight from the freezer)
A lower mains voltage.
Somebody opened the door.
Time will be deducted in case of:
A smaller load.
A warmer load. (defrosted)
Higher mains voltage.
Note that:
In case the time or temperature will be
changed in the cooking program, the heat
number will be adapted with this amount.
THE AUTOMATIC COOK CORRECTION
°C
°C
Extra time
Cooking time
Temparature curve
with half load
The automatic cook correction facility will automaticly add or deduct time to the pro-
grammed cooking time in order to have constant cooking quality.
After programming a new program, the first cooking process will be the “learning” process.
It is recommended to do the first cook with a half load.
The heat number is stored in the cooking
program. In case such a program is cop-
ied with FIPS (see additional software),
the heat number goes with it.
It is possible that in case the program has
changed a lot, the cook correction is not
able to perform well anymore. In that
case the program has to be deleted and
reprogrammed with the good param-
eters.
It is possible to disable this auto cook cor-
rection feature in the service parameters.
See “parameter listings” -> “auto correct.