Switching the interior lighting on/off
X
To switch the interior lighting on/off:
briefly press button
;
.
If you switch on the interior lighting by
briefly pressing the button, the brightness of
the interior lighting is adjusted to approx-
imately 80%.
X
To dim: press and hold button
;
.
The interior lighting brightness can be adjus-
ted between 0 and 100%. When the interior
lighting reaches maximum brightness, it
decreases again. If the interior lighting has
been dimmed to the maximum extent, the
brightness increases again.
Automatic control of the interior light-
ing
X
To switch on/off: press and hold button
A
until a short tone sounds.
If you open the driver's or co-driver's door
and the interior lighting and entry lighting
are switched on automatically, the auto-
matic control has been switched on.
i
There is a delayed switch-off of the interior
lighting if you close the doors while the inte-
rior lighting automatic control is switched
on.
The interior lighting switches off if:
R
you start the engine with the doors closed
R
you close the doors while the engine is
running
R
a door remains open for a longer period
i
If you manually switch on the interior light-
ing when the automatic interior lighting con-
trol is active, the interior lighting remains on
for 15 minutes, or until you:
R
open or close a door
R
manually switch off the interior lighting
If you manually switch on the interior light-
ing and the automatic interior lighting con-
trol is not active, the interior lighting
remains on for 60 minutes.
Switching the nightlight (green) on/off
The nightlight is used as non-dazzle courtesy
lighting while driving.
X
To switch on/off: press button
?
.
Switching the driver's/co-driver's
reading lamp on/off
X
To switch on/off: press button
:
(driver)
or
=
(co-driver).
Rotating beacon
X
To switch on: press the upper section of
the
À
switch.
X
To switch off: press the lower section of
the
À
switch.
When operating the vehicle with the rotating
beacons, observe the applicable national regu-
lations for the relevant country. If the required
field of vision is obscured by trailers, special
bodies or other attachments, make the vehicle
safe by using additional lights.
Notes on replacing bulbs
G
WARNING
Bulbs, lamps and connectors can get very
hot when operating. If you change a bulb,
you could burn yourself on these compo-
nents. There is a risk of injury.
Allow these components to cool down
before changing a bulb.
Bulbs and lamps are an important aspect of
vehicle safety. You must therefore ensure that
all lamps are functioning at all times. The lamp
check supports you in your inspection of the
lamps (
Y
page 102).
Lighting system
51
Driver's
workstation
Z
