Freescale Semiconductor PE Micro Cyclone Pro, Руководство пользователя

Страница: 22 / 158

16 Cyclone PRO User Manual
CYCLONE PRO
BDM users and four schemes for MON08 users. The target board may derive
power by the use of power jacks, or by the use of MON08 connector Pin 15,
or by the use of BDM connector Pin 6, or a combination of both. The options
are explained in detail below. Each configuration will have an associated
jumper setting that MUST be set on the Cyclone PRO. The jumper header is
found on the long side of the unit, opposite from the side where the system
power jack is located.
Note: In order for the Cyclone PRO to handle power sequencing for MON08 targets
automatically, power MUST be provided to the target system by the Cyclone
PRO.
Figure 3-11: Jumper Settings (Rev. C)
3.12.1 Using Power In Jack and Power Out Jack
The target power supply is connected to the Power In Jack of the Cyclone
PRO. The Power Out Jack of the Cyclone PRO is connected to the target
system.
Figure 3-12 shows the connections.