Freescale Semiconductor PE Micro Cyclone Pro, Руководство пользователя

Страница: 143 / 158

Cyclone PRO User Manual 137
CYCLONE PRO
The target GND is connected to the Pin 2 of the target MON08 Header.
The target RESET line is directly connected to the Pin 4 of the target MON08
Header.
The target IRQ line is directly connected to the Pin 6 of the target MON08
Header.
PORTA0 from the target processor is connected to the target MON08 Header
Pin 8, acting as the communications line. The Cyclone PRO pulls up this
signal with a 10K Ohm resistor to the target VDD.
PORTA7, PORTC2, PORTC3 and PORTC4 are used for entering monitor
mode. By default the user may directly bring these signals out to the target
MON08 Header.
Alternatively, the user may pull up PORTC3, pull down PORTA7 and
PORTC4, and pull up/down PORTC2 for clock division. In which case the
user does not need to connect these signals to the target MON08 Header.
13.30 68HC908QL
Figure 13-30: 68HC908QL Family MON08 Pinout
The target GND is connected to the Pin 2 of the target MON08 Header.
The user must pull up the RESET line to target VDD with an external resistor.
The target IRQ line is directly connected to the Pin 6 of the target MON08
Header.
PORTA0 from the target processor is connected to the target MON08 Header
Pin 8, acting as the communications line. The Cyclone PRO pulls up this
signal with a 10K Ohm resistor to the target VDD.
PORTA1 and PORTA4 are used for entering monitor mode. By default the