33
Most incline trainer problems can be solved by
following the steps below. Find the symptom that
applies, and follow the steps listed. If further assis-
tance is needed, please see the back cover of this
manual.
SYMPTOM: The power does not turn on
a. Make sure that the power cord is plugged into a
properly-grounded outlet (see page 14).
b. Make sure that the key is inserted into the console.
c. Check the power switch located on the incline
trainer near the power cord. Make sure that the
power switch is pressed into the on position.
SYMPTOM: The power turns off during use
a. Check the power switch located on the incline
trainer near the power cord (see the draw-
ing above). Make sure that the power switch is
pressed into the on position.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console, and then
reinsert it.
d. Check the walking belt and the walking platform
for excessive wear. Replace the walking belt or the
walking platform if necessary.
e. If the power still turns off during use, please see
the back cover of this manual.
SYMPTOM: The walking belt slows when walked
on
a. If the walking belt is overtightened, performance
may decrease and the walking belt may be dam-
aged. If the walking belt is properly tightened, you
should be able to lift each side of the walking belt
2.5 to 5 cm (1 to 2 in.) off the walking platform. If
adjustments need to be made, first remove the
key and unplug the power cord. Using a 7/32"
hex key, turn both roller adjustment screws coun-
terclockwise 1/4 of a turn. Then, plug in the power
cord, insert the key, and use the incline trainer for
a few minutes. Be careful to keep the walking belt
centered. Repeat until the walking belt is properly
tightened. Note: To tighten the walking belt, see
step c. on page 33.
b. If the walking belt still slows when walked on,
please see the back cover of this manual.
TROUBLESHOOTING
On
c
VMTL
2.5 to 5 cm
Roller Adjustment Screws
a
Содержание FMTK74810.0
Страница 37: ...37 NOTES ...