Freedom LiTE Installation Manual Revision 14
P a g e
7 | 30
4)
End of Life (EoL) defined as cell dropping to 60% of Beginning of Life (BoL) capacity for expected life and 70% of BoL
capacity for warranty.
The ON button [11] and OFF button [12] are located beside the SoC display.
All LiTE
’s have feet as standard, whether needed or not [15].
A hard point is supplied on the top for the 15/12 and 20/16 models [14] for inserting an eye
bolt that can be used for hoisting the battery onto the wall mountings. The LiTE 30/21 and
above are supplied with permanently installed eye bolt(s).
3.
Transport, Handling and Mounting
The Freedom LiTE units are packaged in protective foam inside a wooden crate with pallet
type feet, which allow lifting with a forklift or a pallet jack. The Freedom LiTE Home 5/4 and
10/7 models are easily handled by two people. The 15/11 and 20/14 models may be
manually handled by four people. The 30/21, 40/28, 60/42 and 80/56 models must be
handled with care by a forklift or pallet jack of the required lifting capacity rating.
If it is necessary to transport the LiTE up or down multiple stairs in order to get them to the
point of installation in the premises it may be preferable to select a 20/16 or smaller and
connect multiple in parallel, rather than selecting a single larger model.
The “Home” series is designed for wall mounting
to preserve room and floor space. Each
model is hung on two Rawl Bolts. The Rawl Bolts are inserted into correct diameter
predrilled holes in the wall.
The bolts must first be tightened substantially so that the
internals of the Rawl Bolt have gripped tightly into the wall, and then the bolt must be
turned out slightly with the head protruding so that about 5mm of the bolt shank is
visible. This pre-tightening prevents the bolt from being pushed into the wall when
mounting the LiTE.
The Freedom LiTE has two keyhole shaped holes on the back, which are
shaped to fit over the bolt heads, and then a narrowed section secures around the bolt
shank as the unit is lowered into its final position. The 5/4, 10/7, 15/11 and 20/16 models
are hung using M8 bolts. The centre to centre spacing of these bolts must be applicable to
the model being installed. It is critical that these bolts are mounted within 1mm of the
correct dimension and must be
perfectly level
.
Figure 3.1 Bolt Mounting Keyhole on Rear of LiTE Casing. Warranty Seal and Eye Bolt Hard
Point Also Visible
