Freedom LiTE Installation Manual Revision 14
P a g e
23 | 30
•
51,0V for approximately 70% DoD
In non-CAN Bus systems fitted with DC solar charge controllers (SCC) the AC charger should
stop charging at 53.5V to allow the remainder of the charge to be performed by the SCC.
The SCC voltage set point would be set to 55,8V. For Victron and other fully integrated
systems the LiTE controls this voltage maximum automatically.
Note: For applications where voltages are measured during high current discharge it might
be necessary to adjust slightly the values given above to cater for cell internal resistance.
Note: For systems with an interface between the battery and the rest of the system it is
advisable to use SoC for controlling charge and discharge algorithms as this is the only
accurate method
–
using voltage as described above is only an approximation.
8.
Accessories
Freedom Won offers the following accessories:
Table 7.1 List of Accessories
Item
Description
120 Ohm Termination Resistor
–
RJ45
For plugging into the second CAN port for an
end of line Battery (usually these are supplied
with CAN Enabled inverters and hence it is
generally not necessary to purchase from
Freedom Won).
Eye Bolt M12
Required for lifting 15/7 and 20/14 models
using the hard point on top of the battery
–
for
installation onto the wall.
Gantry
–
see price list for options
Used for lifting LiTE
’s onto wall mount bolts as
well as lifting the floor standing models into the
upright position. Available with various width
gantries (narrower to suit constrained
installations). Requires separate chain block.
Can be disassembled and reassembled in
minutes for easy transportation.
CAN Bus Cables
For various inverters requiring non-standard
cables.
9.
Warranty and Repair
The Freedom LiTE is sealed with a tamper proof warranty seal. It may not be opened by
anyone other than Freedom Won and installers or repairers that have been explicitly
approved by Freedom Won. The warranty on the unit will be void if the seal is damaged or
missing.
