FR500F Series Special Purpose Inverter
- 14 -
Chapter 3 List of Parameter
Group F00
～
F17 are standard function parameters. Group U00 is status monitoring
parameters. Group U01 is fault record parameters.
The symbols in the function code table are described as follows:
"
△
" means the value of this parameter can be modified in stop and running status of drive;
"×" means the value of this parameter cannot be modified when drive is running;
"
⊙
" means this parameter is a measured value that cannot be modified;
Default: The value when restored to factory default. Neither measured parameter value nor
recorded value will be restored.
Setting Range: the scope of setting and display of parameters
FR500F parameter groups are listed below:
Category
Parameter Group
System Parameters
F00: System Parameters
Basic Parameters
F01: Frequency Command
F02: Start/Stop Control Start/Stop Control
F03: Accelerate/Decelerate Parameters
Input & Output Terminals
F04: Digital Input
F05: Digital Output
F06: Analog and Pulse Input
F07: Analog and Pulse Output
Motor and Control Parameters
F08: Parameters of Motor 1
F09: V/f Control Parameters of Motor 1
F10: Vector Control Parameters of Motor 1
Protection Parameters
F11: Protection Parameters
Application Parameters
F12: Multi-Reference and Simple PLC Function
F13: Process PID
F14: Swing Frequency, Fixed Length ,
Count and
Wakeup
Communication Parameters
F15: Communication Parameters
Keys and Display of Keypad
Parameters
F16:Keys and Display of Keypad Parameters
User-defined Display Parameters
F17:User-defined Display Parameters
Monitoring Parameters
U00:Status monitoring
U01:Fault record
