FP 50.0070.0011.00, Установка и безопасность

Страница: 56 / 82

FP S-ENGuard Model series W640 / W667
16
1 KP1 Power
110 - 230 V DC
Power connection (under the protective cover)
2 Pwr Power LED (lights up red when mains voltage is ap-
plied)
3 LAN Ethernet connection, RJ45 port with 2 LEDs
Green LED off = no connection
Lights up = connection established
Flashing = data transfer
Yellow LED off = 10 Mbit connection
Lights up = 100 Mbit connection
4 KX3 1-wire 1-wire interface (1-wire master for max. 30 sensors)
5 SIM unlock Button to unlock the drawer for the SIM card
(depending on model)
6 Antenna (on housing) Connection for mobile communications antenna
(depending on model)
7 USB1
USB2
2 USB host interfaces for connecting USB devices
(memory stick, WiFi stick)
8 PSU OCD PTC overcurrent protection
9 KP2 Relay Out Relay 1 (changeover contact) 240 V / 5 A
10 KP4 Relay Out Relay 2 (changeover contact) 240 V / 5 A
11 KP3 Dig. IN Digital input (Input 1) 240 V
12 KP5 Dig. IN Digital input (Input 2) 240 V
13 KM1 COM3 M-Bus M-Bus interface for 100 end devices
14 KX1 COM1 RS232
COM2 RS485
RS232 interface COM1
RS485 interface COM2, termination switchable via
DIP switch S1
15 S4 Reset button for manual restart (hardware reset, for
developers only)
16 M1.X 2× Pt1000 2 Pt1000 sensor inputs
17 M1.X
M2.X
4× Analogue in-
puts
4 Analogue inputs 0 to 10 V / 0 to 20 mA,
switchable via SA1 to SA8
18 M3.X 3× Analogue out-
puts
3 analogue outputs 0 to 10 V / 0 to 20 mA,
switchable via SA9 to SA11
19 M4.X 5× Digital inputs 5 digital inputs 24 V
20 M5.X 3× Relays 3 relay make contacts (not suitable for mains voltage!)
21 M6.X
M7.X
2 free S1 Sockets 2 free sockets for S1 Expansion module
(on the L2 adapter)
22 DBG Serial debug interface for software developers