VR800 / VR800Z
20
6. INSTALLING INTERNAL DRIVE
The 3.5” internal drive(E-IDE hard disk drive or ATAPI zip drive) installing procedures are explained below.
2)
Loosen 6 x screws (BBT 3 x 8 BZn) fixing the bottom panel of the VR800.
Two cables used to connect to the internal disk appear when you remove the bottom panel.
1)
Using 4 x
inch screws
, fix the bracket (P/N : 8221277000 : Blacket, RHD, VR800) to a 3.5" E-IDE HDD.
Bottom side
40-pin
4-pin
J12
40-pin flat cable
W1
4-pin cable
zip drive
Bottom side
Front side
When installing the ATAPI zip drive (P/N: 8270587000)
supplied from Fostex as a VR800 service part, fix it using the
hole on the bracket indicated below, so that the VR800Z side
panel would be even with the zip drive disk insertion surface.
CAUTION :
• The internal drive must be set to “MASTER”.
• There are 4x inch screws and 8x metric screws are included in the VR800 as well as the VR800Z. When fixing the HDD
to the bracket, use the inch screws. On the other hand, use the metric screws when fixing the zip drive to the bracket.
CAUTION :
When installing the ATAPI zip drive, remove
the side panel prior to the installation.
Содержание VR800
Страница 1: ...VR800 VR800Z Service Manual Model Digital Multitrack Recorder ...
Страница 47: ...VR800 VR800Z 47 NOTE ...