D-160 Owner's Manual (Locate function)
68
Recalling, editing, and storing data
1. Press a memory key for which you wish to recall data. (Alternatively, press the RECALL
key, and then a memory key.)
The D-160 will display the time value stored in the key (bar/beat/clock) and enter
the data edit mode.
2. Use the HOLD/> key or the SHUTTLE dial to move among the digits of the time (bar/
beat/clock), and use the JOG dial to edit them.
3. Press the STORE key. The STORE LED will light.
4. Press a memory key to which you wish to store data.
The retained time value (bar/beat/clock) is stored as memory key data, and the Time
Base display will be restored. The STORE LED goes off.
You do not necessarily have to store the edited data to the memory key that you
pressed to recall the original data. For example, you can press the AUTO PUNCH IN
key to recall its memory data, edit it, and store the data to the AUTO PUNCH OUT key.
* Memory data can be stored for each Program (P1-P99) individually.
* Memory data will be saved and loaded as part of the song data in Setup mode.
* Memory data will be retained after you turn off the power.
* Refer to page "50" for information on the Program Change function.
* Refer to page "102" for information on the save and load operation.
<Hints>
If " Resolution?" menu (bar/beat resolution mode) has been turned on in the Setup mode
when the "BAR/BEAT/CLK" Time Based is being used, press the HOLD/> key or the STORE
key to hold the current bar/beat clock value on the display. You can round off the clock
value to "00" (that is, to a bar/beat value).
This function is very useful when you wish to use the memory data in beat steps.
Refer to page "160" for more information on Bar/Beat Resolution ON/OFF menu in Setup
mode.
