25
WARNING:
An incorrectly mounted brake hose or a hose that is in contact with moving
parts of the bicycle can compromise the braking action and cause serious accidents.
CAUTION:
After the brake has been installed, make sure the handle bar turns freely; if
the brake hose gets in the way, make the required adjustments so that it does not or
contact the manufacturer.
1.3 Installing the caliper
ATTENTION:
never install the FORMULA SRL calipers using adapters or supports made
by other manufacturers. Failure to heed this precaution will void the warranty. Use only
parts manufactured by FORMULA SRL mounted on forks or frames provided to avoid ac-
cidents and serious injury.
CAUTION:
Only correct mounting of the system and it’s various support elements will
ensure the safety of the cyclist and the exceptional performance of FORMULA SRL disc
brakes.
To adapt frames or forks to the various diameters of brake rotors available, FORMULA SRL sup-
plies different adapters which can be mounted between the fork or frame and the brake caliper.
Fit the caliper to the fork, proceeding as follows:
INTERNATIONAL STANDARD MOUNT OR SIMILAR
WARNING! DO NOT DISASSEMBLE OR ATTEMPT MODIFY, THIS NEW
FORMULA SRL PRODUCT!
Service on this product must be performed only by qualified professional me-
chanics who are familar with and understand the technical details of how this
product works.
If you choose to ignore this important safety warning, you are doing so at your
own risk and at no legal liability to FORMULA SRL or its distributors.
CAUTION:
For disc installation, use a dynamometric (Torque) wrench suitable for the
given tightening torque.
CAUTION:
When removing the screws, always make sure that medium strength Loctite®
is applied when reassembling, and that the correct torque wrench settings are used.
R1 - RX - T1 - R1S - R0 – R1 RACING can be used
CAUTION:
Make sure the washers
9
and thread-
blocker are present on screws
9a
and
8
before at-
tempting to start assembly. Apply medium-strength
threadblocker (if not present).
- Place the adapater
6
on the frame (or fork) with the arrow
facing the direction in which the wheel turns.
- Insert the screws and washers
9a
tightening them with
a 5mm hex. socket wrench to a torque setting of
9
Nm±5%.
9
9A
9A
8
9
8
7
6
