INTERNAL WALL BATTENS & BEADED WALL PANELS
Using 4 x 80mm screws, secure a batten between
the two added in Step 206. Repeat on the other
side of the door.
207
207
Secure four 45 x 28mm battens onto the left hand
wall in line with and at the same height as the four
back wall battens. These should be flush end to
end.
208
208
Use 4 x 80mm screws for each of the three smaller
battens.
212
212
214
214
Secure the three shorter 45x28mm battens
between the window and back wall at the same
height as the back wall battens. These will be flush
end to end.
211
211
Use 5 x 80mm screws for each batten. The battens
on the left hand side will not be aligned to the
front batten positions.
209
209
On the right-hand wall, secure a batten at the top
of the wall, in line with the top back wall batten,
using 5 x 80mm screws. Secure a second batten
along the wall so it is flush with the top of the
window frame. Finish framing the window by
securing a 45x25x1960mm batten on either side
of the window using 4 x 80mm screws for each
batten.
210
210
To install the beaded wall panels, start at the back
left-hand corner. Ensure the rounded edge of the
panel is against the left-hand side. Use 4 x 50mm
screws on each side and 2 x 50mm screws into the
panel centre into the middle battens.
213
213
Mark out a guide line underneath all the battens
at both ends. This will ensure that you drill into the
battens when securing the roof panels.
33
