Section 6
APPLIANCES
If You Smell Gas
• DO NOT light any appliance.
• DO NOT touch any electric switch.
• DO NOT use any telephone in the unit.
• Immediately call your gas supplier from an outside phone. Follow the gas suppliers’ instructions.
NOTE: IF YOU CANNOT REACH YOUR GAS SUPPLIER, CALL THE FIRE DEPARTMENT.
Turn On Water Heater
1. Make sure there is water in the water heater, and the LP gas supply is on and LP tank is full.
2. Turn the water heater switch to the ON position.
(Located on the Monitor Panel bezel in the bathrrom.
3. The switch will light along with the DSI FLT light. After a few seconds the water heater will try to
Ignite. If the water heater ignites, the DSI FLT light will go out. If after 3 tries the water heater does
not light, the DSI FLT light will remain on telling you the water heater failed to ignite. If this happens
inspect the water heater for any signs of problems. If you smell gas by the Outside of the water
heater, DO NOT try to light it again. Refer to the above If You Smell Gas.
4. If you do not smell Gas, turn the water heater switch off for a few seconds and then turn it back on.
5. If the water heater fails to light in these three attempts, contact your Aviator dealer.
1. Turn switch to OFF position.
2. Turn off electrical power to the appliance.
3. Turn off gas supply.
4. If vehicle is to be stored or water heater is going to be turned off while subject to freezing temperature,
drain the water heater.
Page 78
Revised September 2012
