Ford Falcon (FG) 2010, Руководство пользователя

Страница: 97 / 264

-97-
Single zone temperature
control
The temperature may be adjusted by
pressing the temperature control button
in the appropriate direction until the
desired temperature is achieved.
The selected temperature will be
displayed on the Interior Command
Centre screen. The temperature can be
set between the range of 18°C and 30°C,
in 0.5°C increments. If a temperature
below 18ºC is selected, then ’LOW’ is
displayed. If a temperature above 30ºC
is selected, then ’HIGH’ is displayed.
Selection of ’H’ (HIGH) will set and hold
the air temperature to maximum heating.
Selection of ’C’ (LOW) will set and hold
the air temperature to maximum cooling
for both driver and passenger.
Cabin comfort level may not be
maintained when ’H’ (HIGH) or ’C’ (LOW)
is selected for extended periods.
The rear console vent outputs
correspond to all Climate Control panel
outputs as set by the Interior Command
Centre.
Note:
The heater maintains warmth
only when the engine is operating. Full
heating is only available when the engine
is at normal operating temperature.
Note: The air conditioner will only
operate with the engine running.
Distribution mode selector
This button may be used to direct the air
to particular groups of outlet vents. Press
the button repeatedly to cycle through
the various distribution options until the
desired setting is shown in the Interior
Command Centre screen. Information
on distribution modes can be found
earlier in this section.
Air conditioning
Press the ’A/C’ button to toggle the air
conditioner on/off.
Note: If the blower fan is off and A/C is
turned on the fan will automatically come
on.
Note:
If the climate control system
is OFF and the A/C is turned ON the
system will start in ’AUTO’ operation at
the last selected temperature setting.
Note: The air conditioner will only
operate with the engine running.
At most ambient conditions, maximum
cooling efficiency is automatically
achieved in AUTO mode. However,
maximum cooling can also be obtained
by overriding AUTO operation and
selecting recirculated air, face vents and
lowest set temperatures.
Climate control