Delay (H)
(
H
in
Total Delay)
indicates amount of horizontal delay and their settings correspond to
the following adjustable ranges.
Delay (H) Setting
Adjustable range
Delay (H) Setting
Adjustable range
0.3H
-0.8H to +0.2H
0.8H
-0.3H to +0.7H
0.4H
-0.7H to +0.3H
0.9H
-0.2H to +0.8H
0.5H
-0.6H to +0.4H
1H (1)
-0.5H to +0.5H
0.6H
-0.5H to +0.5H
1H (2)
-0.1H to +0.9H
0.7H
-0.4H to +0.6H
If
Total Delay
(frame) is set to “
0 frame
” for both Gearboxes, a
Total Delay (H)
setting is selectable
for each Gearbox.
5-3. Conversion Settings
In the WebGUI, specify the Gearbox input and output formats, and then assign input/output
physical channels to logical channels. Use Link Settings that allow simultaneous 4-channel
operation and facilitate crosspoint switches.
5-3-1. Converting 3G SQD input to 2SI (MFR-2SDIGB)
1.
Open the
Gearbox Settings
page in the WebGUI and select signal formats under
From
and
To
as shown below for a Gearbox in the MFR-2SDIGB card block. (This
example sets Gearbox 1 on the Slot 4 card.)
2.
Open the
Source Assignment
page in the WebGUI and assign the physical
channels (
SDI29-32
) to logical channels (
SRC 1-4
).
3.
Use a remote control unit or the Crosspoint page in the WebGUI to assign output
channels to
SRC1-4
.
MFR-2SDIGB
MFR-6000
routing
Gearbox 1
Quad Link
3G-SDI
(SQD)
Quad Link
3G-SDI
(2SI)
