Foppapedretti RE-KLINO, Руководство пользователя

Страница: 21 / 72

RE-KLINO
21
When the adjustment has been made, release the tension adjustment lever and ensure it is
locked correctly in place.
Adjusting the headrest
A correctly adjusted headrest ensures that the vehicle’s diagonal belt is in the correct
position to ensure optimal protection for the child.
The headrest must be adjusted so that two fingers can fit between the
headrest and your child’s shoulders.
Adjust the headrest based on your child’s build:
Press the headrest adjustment lever located on the back (1-F)
Raise or lower the headrest based on your child’s build (1-G). Release the lever to lock it in
the required position. Ensure it is correctly locked in place.
Place your child on the seat and ensure that the adjustments have been made correctly (1-
H). Repeat these steps if necessary.
5-point belt adjustment (use for group 1)
1. Press the strap adjustment button A and, at the same time, pull the straps (chest belts)
grasping them from below, under the protective chest padding, to slacken them (2-A).
IMPORTANT: Do not pull the straps by the protective chest padding.
2. Press the button (B) and undo the belts. Position the belts to the side of the seat (2-B)
& (2-C).
3. Place your child on the car seat and do up the harness. Join the two connectors of the
buckle and slide them into the central buckle. It will click when it is closed correctly (2-D).
4. Pull the strap adjustment belt (C) to correctly adjust belt tension based on your child’s
build. Ideally the harness should be adjusted so that there is space for one finger (1 cm)
between the harness and your child’s body (2-E).
Attention! The hip belt must be positioned as low as possible over your child’s pelvis.
Attention! Do not twist or turn the chest belts inside out (2-F).
INSTALLATION IN THE VEHICLE
INSTALLATION IN GROUP 1. Children between 9 and 18 kg
Attach the child car seat to the vehicle seat using the vehicle’s 3-point belt, as follows:
1. Leave a space between the car seat and the backrest of the vehicle seat. Pull the vehicle’s
3-point belt and join the chest part to the hip part of the belt by approximately 80 cm (3-A).
2. Slide the part of the joined (chest and hip) 3-point belt through the belt slot (3-B) between
frame and fabric, and fasten the buckle (3-C). The click tells you it is locked properly. Ensure
that the belt is not twisted, adjust belt tension by pulling the hip part.
Notes: Ensure that the 3-point belt is slotted between frame and fabric and that it does not
pass in front of the mobile fabric part of the headrest.
3. Fasten your child in by the 5-point belt (3-D).
GB