FOLSOM Blend PRO BP-2002, Инструкция по установке и эксплуатации

Страница: 60 / 89

46
BlendPRO – Wide Screen Image Processor Manual # 26-0206000-00 / Revision A
Blend Setup Menu
The Blend Setup Menu allows the user to control display configurations, edge blending functions, and output image
configurations for the overlapped regions of the output display. This menu can be accessed from the SETUP MENU
or by pressing the
BLEND ADJ hot key on the front panel. Configuration parameters entered in this menu are saved
in non-volatile memory using the SAVE CHANGES menu item. If the SAVE CHANGES menu item is not selected,
the information will not be restored upon the next system power up sequence.
Blend Level
There are two blend level menu modes, BASIC and ADV (ADVANCED). The Basic Blend level is sufficient for most
users to configure a system and verify the equipment operation. The Advanced Blend level provides expanded
controls for edge feathering functions
. The selection controls the functions available in the EDGE BLEND SETUP
sub-menu.
Projectors
The number of projectors to be driven by the BlendPRO is selectable with this menu item. Each BlendPRO can drive
up to four projectors in a wide screen presentation. Two BlendPROs can be linked to support up to 8 screens. Set
this control to “1-4” if the BlendPRO controls from one to four projectors. Set this control to “5-8” if this BlendPRO is
the second of two units used to control more than four projectors. Note that a DVI cable is required to link the
BlendPRO units if more than four projectors are used.
Total Projectors
The total number of projectors being driven in a Wide-screen display application is selectable with this menu item.
The total number of projectors can be from 1 to 8. For widescreen display applications with more than four projectors,
a second BlendPRO is required. The maximum number of projectors is limited based on the source material
justification selected. If left display justification is selected the maximum is 8 projectors. If center display justification is
selected the maximum number of projectors is 7.
Display Setup Submenu
The Display Setup menu item is used to call up a submenu where data doubling mode, justification selection and
overlap width adjustments are performed. The Display Setup submenu configuration items are described below.
BLEND SETUP
BLEND LEVEL BASIC
PROJECTORS 1-4
TOTAL PROJECTORS 4
DISPLAY SETUP >>
FEATHERING SETUP >>
OUTPUT IMAGE ADJ >>
SAVE CHANGES