FOLSOM Blend PRO BP-2002, Инструкция по установке и эксплуатации

Страница: 43 / 89

Manual # 26-0206000-00 / Revision A BlendPRO – Wide Screen Image Processor 29
Detailed Instructions for Configuring a Wide-Screen
Presentation
1. System Configuration
Use BlendWizard to select one of the standard BlendPRO Configuration Files or to generate and store an application-
specific file. The BlendWizard output provides the basic information required to define the system configuration.
2. Equipment Setup
Connect the image sources, BlendPRO and projection devices as required for the application. Connect the
BlendPRO remote port to an available ScreenPRO port on the ScreenPRO Plus. Connect the Controller to the
ScreenPRO Plus. Connect a laptop with the BlendWizard application installed to the Controller Serial Port (DB-9
CONSOLE). Refer to figures 2-2, 2-3, and 2-4 for detailed connection information. Turn on all the equipment.
Setup BlendPRO’s serial mode to RS-485 in the SYSTEM OPTIONS menu and select a RS-485 ID.(this setting can
be found in SYSTEM OPTIONS->CONFIG SERIAL menu.) The RS-485 ID number can be set from 1 to 32. The
BlendPRO RS-485 ID in a multi-screen configuration must be set to follow the ScreenPRO IDs. In a four-screen
configuration (see figure 2-2) the BlendPRO ID must be set to 5. In a five-screen Configuration (see figure 2-3) the
first BlendPRO ID must be set to 6 and the second BlendPRO ID must be set to 7. In a six-screen configuration (see
figure 2-4) the first BlendPRO ID must be set to 7 and the second BlendPRO ID must be set to 8.
The Controller must be turned on after BlendPRO and ScreenPRO Plus have booted completely. The Controller
display will show BP: N (N being the number of BlendPRO(s) it detects.) If BP: 0 is shown, check the connection from
the ScreenPRO Plus frame to the BlendPRO, make sure that the BlendPRO serial mode is set to RS-485 and the
proper RS-485 ID has been selected as explained above. Reboot the Controller. When it detects the number of
BlendPRO(s) that are connected to the ScreenPRO Plus chassis, run the BlendWizard application.
3. System Configuration and Adjustments
The BlendWizard will walk you through a series of steps required to configure and adjust the system. The steps are
outlined below for reference, however, BlendWizard automates much of the process.
STEP 1: Projector Clock Phase Adjustment
Set the BlendPRO to output the Pixel On–Pixel Off Test Pattern on all output channels. Adjust the sample
clock phase of each projector to obtain an output image that is free of artifacts (Please refer to the operating
manual for your projector for detailed instructions).
STEP 2: Projector Horizontal and Vertical Sampling Adjustments
Configure BlendPRO to output the Output Raster Box Test Pattern on all output channels. Adjust the
Horizontal and Vertical Position of the output image from each projector until the edges of the Raster Box
test pattern align with the edges of the output display area.
STEP 3: Projector-to-Projector Color Balance Adjustment
Set BlendPRO to output one of the following test patterns:
BLACK (0% Gray)
GRAY 25%
GRAY 50%
GRAY 75%
WHITE (100% Gray)
HRAMP