FOLSOM Blend PRO BP-2002, Инструкция по установке и эксплуатации

Страница: 30 / 89

16
BlendPRO – Wide Screen Image Processor Manual # 26-0206000-00 / Revision A
Video Output Connections
Two independently buffered outputs (one five wire BNC connection and one HD-15) are provided for each output
screen. Either of these outputs may be used to connect to the display device used for the presentation. The second
output is designed to support a local display in the event that the operator is unable to conveniently view the
presentation.
Both outputs provide RGB video signals. Connect the outputs labeled R,G, and B on the rear panel of the BlendPRO
unit to the correspondingly labeled connectors on the projector.
The operator can select the type of output sync to match application requirements. Separate C (Composite) or
separate H/V (Horizontal/Vertical) sync modes are supported. Connect the C or H sync signals from BlendPRO to the
correspondingly labeled connectors on the projector. If separate H/V sync mode is being used, be sure to connect the
V signal from the BlendPRO to the correspondingly labeled connector on the projector.
RGB Output
Pin 1 RED
Pin 2 GREEN
Pin 3 BLUE
Pin 4
Pin 5
Pin 6 RED return
Pin 7 GREEN return
Pin 8 BLUE return
Pin 9
Pin 10 GND
Pin 11
Pin 12
Pin 13 Hsync or Csync
Pin 14 Vsync
Pin 15
1 5
11 15
6
HD-15 Output Connector Pinout
(as viewed from rear of unit)
*NOTE: Composite sync or separate Hsync and Vsync signals as well as Sync on Green are supported.
Format – RGBHV
(Typical Devices: Projectors)
Sourced from BlendPRO
TM
R Red
G Green
B Blue
H Hsync/Csync
V Vsync