FOLSOM Blend PRO BP-2002, Инструкция по установке и эксплуатации

Страница: 57 / 89

Manual # 26-0206000-00 / Revision A BlendPRO – Wide Screen Image Processor 43
Input Setup Menu
The Input Setup menu allows the operator to fine-tune video parameters to control the position of the image as well
as to adjust contrast, brightness, and color balance. The Input Setup Menu is illustrated below. This menu can be
accessed from the SETUP MENU or by pressing the
IN ADJ hot key on the front panel. Configuration parameters
entered in this menu are saved in non-volatile memory for each input source using the SAVE CONFIG menu item. If
the SAVE CONFIG menu item is not selected, the information will not be restored upon the next system power up
sequence. The SAVE ALL CONFIG menu item saves configuration parameters for all input sources.
The above menu will be displayed if a valid video input is connected to the selected input channel. Note that all input
video sources must be identical in format. If a valid input source is not connected, the following message will be
displayed:
Channel 1 is the master video source for the BlendPRO controlling the first four screens of a multi-screen
presentation. The DVI link provides the master video source for the second BlendPRO controlling screens five and
above of a multi-screen presentation. BlendPRO requires a valid video source to be connected to its master video
source to allow Input Setup configuration. If a master video source is not available, a grid test pattern will be
automatically output to all video outputs. Note that it will not be possible to complete BlendPRO setup unless a valid
master video source is connected.
Hactive(Pixels) x Vactive(Pixels) @ Frame Rate
This informational menu item shows the input videos horizontal and vertical active resolution and it’s frame rate. This
menu item cannot be edited by the user.
INPUT SETUP 1
1024x768 @ 59.94Hz
INPUT SELECT 1
HTOTAL 1334
PHASE 0
HPOS(PIXELS) 259
VPOS(LINES) 18
CONTRAST 100.0%
BRIGHTNESS 100.0%
AUTO COLOR BALANCE
RGB COLOR BAL >>
RESET CONFIG
SAVE CONFIG
SAVE ALL CONFIG
NO INPUT ON CH X
PLEASE CHECK CABLES
<ESC> TO CLEAR MSG