CAUTION!
§
Wear rubber gloves and safety goggles (or face shield) when handling cleaner or sanitizer mixtures .
§
Use only Follett approved cleaners .
§
It is a violation of Federal law to use the Cleaning or Sanitizing solution in a manner inconsistent with their
labeling .
§
Do not use solvents, abrasive cleaners, metal scrapers or sharp objects to clean any part of the dispenser .
Cleaning Solution: Mix cleaning solution of 1 gal . (3 .8 L) 100 F (38 C) water and 7 oz . (198 g) (one 7 oz . packet) of
Follett SafeCLEAN ice machine cleaner/descaler (P/N 00132001) .
Sanitizing Solution: Mix a sanitizing solution of 1 gal . (3 .8 L) 100 F (38 C) water and 1 .6 oz . (47 ml) Nu-Calgon IMS-II or
IMS-III Sanitizer (P/N 00979674) .
Cleaning/descaling procedure
Note: Check drains and drain cup to ensure they are open and flowing freely .
1.
If ice machine was running recently, ensure that the evaporator is completely free of ice before proceeding .
If there is ice in the evaporator, complete steps 2-7 using only hot water to remove the ice then begin
Cleaning/Descaling Procedure again .
2. Remove front or top cover .
3. Disconnect bin signal cable from ice machine electrical box .
4. Press CLEAN switch . The MAINTENANCE light will turn on and the machine will drain . Wait for the LOW
WATER light to turn on .
5. Remove lid from cleaning cup and fill (about 1 quart) until cleaning solution completely fills the reservoir .
Place lid back on cup .
6. CLEANER FULL light will turn on and machine will start cleaning cycle then rinse three times; this process
takes approximately 15 minutes .
7. When machine is finished cleaning, the MAINTENANCE light will turn off .
Sanitizing Procedure
8. Press CLEAN switch . The MAINTENANCE light and LOW WATER light will turn on .
9. Fill cleaning cup with sanitizing solution until completely fills the reservoir . Place lid back on cup . Save
remainder of sanitizing solution .
10. CLEANER FULL light will turn on and machine will start sanitizing cycle then rinse three times; this
process takes approximately 15 minutes .
11. When machine is finished rinsing, the MAINTENANCE light will turn off . Remove top bearing insulation and
nozzle insulation, then loosen phillips-head screw on nozzle connected to evaporator . Remove nozzle from
evaporator side only, leave other side of nozzle connected to transport tube .
12. Place one Sani-Sponge in remaining sanitizing solution .
13. Insert the sponge soaked in sanitizing solution into nozzle then insert a dry sponge into the nozzle .
14. Replace nozzle onto evaporator and tighten screw . Ensure drain is connected to reservoir and vent tubes
are connected to evaporator drain pan .
15. Reconnect bin signal cable . Wait for ice to push sponges through transport tube .
16. Collect sponges from ice storage bin .
17. Replace front or top cover .
18. After 10 minutes, dispense all ice and discard .
19. Clean/descale and sanitize dispenser/bin .
User Interface and Exterior Cabinet
§
Clean stainless steel panels with stainless steel cleaner .
8
MCD425A/W, R425A/W, MFD425A/W, P425A/W Ice Machines
