What is wrong when,….
Q:
My
lift stops when closing the spa
as soon as the rear cover settles down ?
A:
The stop nut in the carriage mechanism is not adjusted correctly. The controller misinterprets
the wrong tilted front cover as an obstacle since the cover does not move down freely.
Use an allen key to adjust the stop nut inside the carbon support:
The setup is correct when the forward cover, when laterally viewed is a few degrees tilted towards
the front spa panel when the back cover rests flat on the spa shell.
Start adjustment on one side. Once a correct position of the nut is found copy that adjustment to
the other side. Close the spa and open again. Check for correct tilt and if necessary repeat above
steps.
________________________________________________________________________
Q:
I see a small
imbalance between the carbon arms
when opening the spa.
A:
The drive that runs after, is loose.
Open the spa half way until the forward cover is tilted approximately vertical.
Take off the circlip from the slider pin and disconnect the slider form the dowel pin.
Move the arm manually forward and back and check the possible travel distance.
Max allowed swivel is 15mm (approx. 1/2 inch) at the tip of the arm.
If the distance is greater , unscrew the black drive cap. Check the tightness of center allen screw.
If the screw is loose, move the arm manually forward and back while tightening the screw.
The possible way of travel will become more narrow while tightening the screw.
Tighten the screw firmly.
Put the black drive cap in place and reconnect the slider to the pin, put on the circlip.
Initiate a manual alignment.
________________________________________________________________________
Q:
I
cannot control my spa lift with the smart key
. The App control works fine.
A:
Smart key and Bluetooth remote control interfere that way that App control has priority.
Always close the App remote control screen when not in use in order to be able to control the lift on
the Smart key panel properly.
________________________________________________________________________
Q:
There was a metallic noise and suddenly
one drive is loose
.
A:
Lift loading revealed an installation fault. When the drive was put in position on the drive base,
the corresponding cogs of the drive base and the mounting bracket were not aligned properly.
A change in lift load or an overload condition aligned the cogs then and the resulting gap between
the surfaces allows the drive to move.
See also Q&A - Imbalance between arms when opening, for corrective action.
17
