5
1.1.2 General Safety Instructions
Danger:
To avoid danger to life or limb, please ensure that all personnel involved in installing or dismantling
this system have read and understood the contents of this manual.
The information presented here should, however, be regarded as accompanying advice and it does
not affect the ultimate responsibility of the user to ensure safe on-site operation of a
LINEA FOCUS
system.
Warning:
To prevent injury caused by a fallen system,
this device must be securely mounted in accordance with the assembly instructions and
current safety guidelines. Only use the specially designed
FOHHN
mounting accessories or
components, which are explicitly specified in the assembly instructions.
this device must be regularly inspected for any signs of wear or loosening of the load-bearing
connections.
it is necessary to ensure that the mounting points on a building or structure have sufficient
load-bearing capacity and are structurally viable.
all components of a hung (i.e. “flown”) device must be visually inspected before installation.
Any part showing signs of deformity, cracks, rust, fractured welds or other signs of wear must
not be used under any circumstances.
the load limit of any component that will be used for system suspension (including shackles,
chains and hoists) must not be exceeded. In order to comply with local safety regulations,
these load limits may, in certain circumstances due to underlying safety factors (operating
ratios), need to be recalculated and, if necessary, reduced.
All components required for the mounting or suspension of a
LINEA FOCUS
system have
been designed and constructed in accordance and compliance with the following regulations
that are applicable in Germany: BGV-C1, BGI 810-3, DIN EN 1993-1-1, DIN EN 1999-1-1 and
DIN 18032-2. The safety factor (operating ratio) is therefore equal to or better than 10:1. If
the system is to be used in countries that have stricter requirements, the permissible load
capacity must be reduced accordingly.
To avoid injury, the device must be stored, installed and operated well away from children.
To avoid injury, this device must be taken out of operation, marked appropriately and protected
against accidental use if it
shows visible signs of damage,
appears to contain loose parts,
is not working correctly,
has been subjected to unfavourable conditions (e.g. moisture) for a prolonged period,
has been subjected to poor transportation conditions (e.g. with unsuitable packaging or
humidity).
If necessary, please contact your FOHHN dealer or the transport company immediately.
Содержание DLI-230
