TView Pro AV 1600 User's Manual Rev 1.02
11
2.2 MAC Desktop Version
Follow these steps to install your Desktop TView Pro AV 1600 for Macintosh systems. If you intend to use the
TView Pro AV 1600 with Genlock or component output please see Appendix C (Genlock operation) and Appendix D
(Component output) for further information on these features.
1.
Turn the computer off.
2.
Select a convenient location for the TView Pro AV 1600.
3.
Disconnect the Computer Display from the Computer Graphics device at the Computer Graphics device.
4.
Using the Macintosh Adapters connect one end of the PC video cable into the graphics card on the computer
(The location from which the computer display was removed). Connect the other end of the cable into the VGA
In connector of the TView Pro AV 1600.
5.
Using the Macintosh Adapter connect the computer display to the video out connector on the TView Pro AV
1600.
6.
Connect your Video Device to the Composite Video and/or S-Video output connector. (You may connect both
outputs simultaneously to the same or different Video Devices: Video is always available on both these outputs.)
7.
Plug the 13.5 VDC Power Supply's jack into the TView Pro AV 1600’s power input (marked 12-18 VDC, 23W, 2.5
mm).
8.
Plug the 13.5 VDC Power Supply into an electrical outlet. (If you have a Universal Power Supply, you will have
to supply an appropriate IEC-320 compatible power cord for your country).
9.
Turn the TView Pro AV 1600On.
10.
From the Front Panel or RS-232/422 control, set the Sync Selection to “IN= MAC SYNC”. (See section 3.1.19 for
additional details on Sync Selection.)
11.
Turn the System On. If everything is correctly installed, you will see your computer's normal power up sequence
appearing on both the Computer Display and the Video Device (if the Video Device has a visible display).
