Focus HyperConverter 1024, Руководство пользователя

Страница: 31 / 54

HyperConverter User’s Manual 0006-5000-503 31
If pass through of the Computer Graphics signal to a Computer Graphics Monitor is NOT required, set
the "75 OHM IN" switch to the 75 OHM IN position (Up). DO NOT USE the Unterminate switch
accessible from the front panel. Make sure that this switch is always in the "Terminate" (Up) position.
If pass through of the Computer Graphics signal to a Computer Graphics Monitor is required, set the
"75 OHM IN" switch to the 75 OHM OUT position (Down). DO NOT USE the Unterminate switch
accessible from the front panel. Make sure that this switch is always in the "Terminate" (Up) position.
Connect the workstation's monitor to the "OUT" BNC connectors of the Rackmount HyperConverter
with second 5 BNC Male to 5 BNC Male Cable (Part # 0107-2000-100; not supplied unless
specifically ordered). Connect the appropriate connectors for 3, 4 or 5 wire sync.
Turn the HyperConverter On.
Turn the Computer and Output Video Systems On. If everything is correctly installed, you will see
your computer's normal power up sequence appearing on both the Computer Display and the Video
Device (if the Video Device has a visible display).