Focus HyperConverter 1024, Руководство пользователя

Страница: 29 / 54

HyperConverter User’s Manual 0006-5000-503 29
Turn the HyperConverter On.
Turn the Computer and Output Video Systems On. If everything is correctly installed, you will see
your computer's normal power up sequence appearing on both the Computer Display and the Video
Device (if the Video Device has a visible display).
2.7.4 Rackmount HyperConverter Installation for SGI Workstations
Turn the workstation off.
Select a convenient location for the HyperConverter.
Disconnect the SGI's High Resolution Monitor from the computer.
Connect the "IN" connectors of the Rackmount HyperConverter to the Sun with a 13W3 Male to 4
BNC Male Cable (Part # 0101-2000-100; not supplied unless specifically ordered). Only 3 connectors
of this cable (Red, Green and Blue) must be connected.
Set the "SEP SYNC" switch on the Back Panel of the HyperConverter to the COMP SYNC position
(Down). Set the "SYNC ON GREEN" switch to the SYNC ON GREEN position (Up).
Connect the television compatible device. Depending on your choice of type of output video, this will
require 1, 2, or 4 BNC cables for composite, S-Video or component respectively. If you require S-
Video output on a 4 pin DIN connector, use a 2 BNC Male to 4 pin DIN accessory cable (Part #
0108-2000-100; must be ordered).
Plug the HyperConverter into AC power with an IEC-320 compatible power cable (American plug
configuration is part # 0020-2001-100; supplied with each unit). If you are outside North America,
you will have to supply an appropriate IEC-320 compatible power cord for the country that you are in.
If pass through of the Computer Graphics signal to a Computer Graphics Monitor is NOT required, set
the "75 OHM IN" switch to the 75 OHM IN position (Up). DO NOT USE the Unterminate switch
accessible from the front panel. Make sure that this switch is always in the "Terminate" (Up) position.
If pass through of the Computer Graphics signal to a Computer Graphics Monitor is required, set the
"75 OHM IN" switch to the 75 OHM OUT position (Down). DO NOT USE the Unterminate switch
accessible from the front panel. Make sure that this switch is always in the "Terminate" (Up) position.
Connect the SGI's monitor to the "OUT" BNC connectors of the Rackmount HyperConverter with a
13W3 Female to 4 BNC Male Cable (Part # 0102-2000-100; not supplied unless specifically ordered).
Only 3 connectors of this cable (Red, Green and Blue) must be connected.
Turn the HyperConverter On.