Focus HyperConverter 1024, Руководство пользователя

Страница: 27 / 54

HyperConverter User’s Manual 0006-5000-503 27
Turn the HyperConverter On.
Turn the Computer and Output Video Systems On. If everything is correctly installed, you will see
your computer's normal power up sequence appearing on both the Computer Display and the Video
Device (if the Video Device has a visible display).
2.7.2 Rackmount HyperConverter Installation for MACs
Turn the workstation off.
Select a convenient location for the HyperConverter.
Disconnect the MAC's High Resolution Monitor from the computer.
Connect the "IN" connectors of the Rackmount HyperConverter to the MAC with an DB15 to 4 BNC
Male Cable (Part # 0104-2000-100; not supplied unless specifically ordered). All 4 connectors of this
cable must be connected. Make sure that the Composite Sync connector of this cable is attached to the
H IN connector of the Rackmount HyperConverter.
Set the "SEP SYNC" switch on the Back Panel of the HyperConverter to the COMP SYNC position
(Down). Set the "SYNC ON GREEN" switch to the SYNC ON COMP position (Down).
Connect the television compatible device. Depending on your choice of type of output video, this will
require 1, 2, or 4 BNC cables for composite, S-Video or component respectively. If you require S-
Video output on a 4 pin DIN connector, use a 2 BNC Male to 4 pin DIN accessory cable (Part #
0108-2000-100; not supplied unless specifically ordered).
Plug the HyperConverter into AC power with an IEC-320 compatible power cable (American plug
configuration is part # 0020-2001-100; supplied with each unit). If you are outside North America,
you will have to supply an appropriate IEC-320 compatible power cord for the country that you are in.
If pass through of the Computer Graphics signal to a Computer Graphics Monitor is NOT required, set
the "75 OHM IN" switch to the 75 OHM IN position (Up). DO NOT USE the Unterminate switch
accessible from the front panel. Make sure that this switch is always in the "Terminate" (Up) position.
If pass through of the Computer Graphics signal to a Computer Graphics Monitor is required, set the
"75 OHM IN" switch to the 75 OHM OUT position (Down). DO NOT USE the Unterminate switch
accessible from the front panel. Make sure that this switch is always in the "Terminate" (Up) position.
Connect the MAC's monitor to the "OUT" BNC connectors of the Rackmount HyperConverter with a
second DB15 to 4 BNC Male Cable (Part # 0104-2000-100) and an DB-15 Gender changer (Part #
0106-2000-100, not supplied unless specifically ordered). Make sure that the Composite Sync
connector of this cable is attached to the H OUT connector of the Rackmount HyperConverter.