FNM HPEP 225, Руководство по установке

Страница: 36 / 123

36
TAPE MEASURE METHOD
Transom angle must be known, then measure "X" Dimension with tape measure.
1. Select "X" Dimension from Tape Measure Method Chart that corresponds to transom
angle.
Tape Measure Method Chart
Model All Alpha and Bravo
Transom Angle
(degrees)
This dimension should only be raised or lowered after proper
testing.
16° 14-5/16 in. (364 mm)
15° 14-1/4 in. (362 mm)
14° 14-3/16 in. (360 mm)
13° 14-1/8 in. (359 mm)
12° 14-1/16 in. (357 mm)
11° 14 in. (356 mm)
10° 13-15/16 (354 mm)
2. Follow instructions "a" or "b":
a. For Single Engine Applications:
(1.) Measure and layout horizontal line as shown.
(2.) Locate and mark center of horizontal line.
(3.) Draw a vertical line from the bottom of the transom to the center mark on horizon-
tal line.
(4.) Measure upward from bottom of transom to the "X" Dimension selected
previously. This is the crankshaft horizontal centerline.
a - Crankshaft Horizontal Centerline
b - Mark On Horizontal Centerline
c - "X" Dimension that Corresponds to Transom Angle
d - Vertical Centerline