Operating Instructions EMGZ492.PNET
05.10.2018
18
Nominal force B
The nominal force indicates the measuring capacity of
force sensor B. E.g., if a 500 N load cells is installed 500
N must be entered.
Unit
N
Min.
1.00
Max.
200‘000.00
Specified value
1‘000.00
Limit frequency low-
pass filter actual value
B
The amplifier features a low-pass filter that filters the
measured value is relayed via PROFINET. This filter is
used for suppressing undesired interference signals that
are superimposed on the measuring signal. Using this
parameter, the limit frequency of the filter of force sensor
B is adjusted. The lower the limit frequency, the slower
the measuring value.
This low-pass filter is independent from the output filter.
Unit
Hz
Min.
0.1
Max.
200.0
Specified value
10.0
Low-pass filter analog
output active
Here, the status of the low-pass filter for the analog
output is indicated.
This parameter cannot be accessed via the web interface.
Min.
0
Max.
1
Specified value
1
0 = no, inactive, 1 = yes, active
Limit frequency low-
pass filter analog
output
The amplifier features a low-pass filter that filters the
signal of the analog voltage output. This filter is used for
suppressing undesired interference signals. Using this
parameter, the limit frequency of the filter is adjusted.
This low-pass filter is independent from the PROFINET
filter.
Unit
Hz
Min.
0.1
Max.
200.0
Specified value
10.0
