www.fmiproducts.com
56131L
23
FIREPLACE INSTALLATION
Continued
You may test blower for operation by turning
control knob clockwise just until it clicks on
which is the full on position. Adjust fan speed
to lowest setting (this should be no more than
1/4 of a turn clockwise).
OFF
P
IL
O
T
ON
LO
HI
PI
LOT
E
A
16AI
7
TPTH
TP
TH
INSTALLING OPTIONAL WIRELESS HAND-
HELD REMOTE CONTROL MRC-SERIES
Note: If using an optional wireless hand-
held remote control, wall switch is no longer
operational.
NOTICE: Only use alkaline bat
-
teries (not included).
Installing Remote Receiver
1. Open bottom louver and locate switch
bracket on the right.
2. Remote receiver can be placed in the
hole on the switch bracket or place on the
floor underneath the firebox. See remote
instructions for further information.
3. Attach terminal wires to battery.
4. Connect wires from receiver to TH and
TPTH to control valve (see Figure 38).
Gas
Valve
To Thermopoile
Extension
Cord
Outlet Box
White
Red
Figure 39 - Installing Remote Receiver
(SKYTECH Model)
Optional Fan
Kit Plug
Receiver
Pull to Remove
Insulation Tab
Battery
Cover
12 Volt
Battery
Figure 40 - Installing Battery in Hand-
Held Remote Control Unit (SKYTECH)
Figure 37 - Connecting Blower
Accessory to Power Supply
For Optional
Fan Kit
From Blower
Assembly
Installing SKYTECH/WRC Model Remote
Control (Electronic Models Only)
1. Remove lower louver access panel in
fireplace (see step 1 of
Wall Switch Instal-
lation
, page 22).
2. If a wall switch was installed, it must be
removed from ignition control circuit for
remote to work properly. Remove wire
nuts from switch connection at ignition
control module. Using wire nut, connect
transformer (blue) wire to remaining wire
connected to control terminal marked
P.SW (see Figure 34, page 22).
3. The receiver does not require a battery.
To install, plug extension cord into one of
the outlet receptacles on outlet box. Plug
receiver unit into extension cord and igni-
tion module into receiver unit (see Figure
39).
4. Replace louvered access panel by follow-
ing reverse steps on page 22.
5. Activate handset battery by removing
insulating tab on back (see Figure 40).
Figure 38 - Control Valve Terminals
To Optional
Remote
Accessory
To Wall
Thermostat
