www.fmiproducts.com
126417-01A
16
Figure 28 - Ignitor
IGNITOR ASSEMBLY
The ignitor assembly is factory preset for
proper ignition of the burner. Alterations may
have occurred during shipping and handling.
Call a qualified service person to readjust the
ignitor assembly if necessary.
The ignitor should be positioned as shown
in Figure 28.
Note: Figure 28, shows the correct positioning
of the ignitor and sensing rod.
If your ignitor assembly does not meet these
requirements:
• turn appliance off (see
To Turn Off Gas to
Appliance
, page 17).
• see
Troubleshooting
, page 18
INSTALLATION
Continued
OPERATION
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per
-
sonal injury or loss of life.
A. This appliance does not have a pilot,
it is equipped with an ignition device
which automatically lights the pilot. Do
not light pilot by hand.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
Ignitor
Ground
Electrode
0.8000
Sensing
Rod
Spark
Gap
0.120
Note:
Reference only, not to scale
